When Halloween rolls around, you don’t have to be an artist— or even think you’re particularly creative—to feel the pull of the pumpkin. The pumpkin reminds us of our childhood, of times when the whole family gave it their best shot. We knew that if our pumpkins weren’t perfect, they would rot and that would be the end of the embarrassment. And this is true today, my friends. Pumpkins still rot. So take a chance!
Last year, I sculpted some puppy pumpkins and sent the photos to the editor. Which is how I came to be invited write this piece. Even if you believe you’re not an artist, I encourage you to try this. Why? Because Bark and its readers inspired me to start pumpkin carving in the first place.
My technique involves removing the skin and sculpting the meat of the pumpkin, varying the wall thickness to create the design. When you punch through to the cavity of the pumpkin, you have a dark pumpkin with a flaming hot yellow color inside when it is lit. But if you don’t cut all the way through, you can create many layers of color.
• Find a photo or take a snapshot of the dog you wish to sculpt, either facing you or a side view. Print it out on an 8.5 x 11 sheet of paper for reference.
• Open the pumpkin. Use a sturdy knife (with a six- or seven-inch blade), just like you do for a traditional pumpkin. Create an opening in the top large enough to get your hand inside. To make sure the lid will not fall inside, angle the knife so that the tip tilts toward the stem and the handle tips toward you. This creates a shelf for the lid to rest on. Carefully work around until the lid is free, and then lift it out. (Reminder: Do not place your free or pumpkin-holding hand in front of the blade as you are cutting.) Clean out your pumpkin.
1. Take the large loop tool, hold it flat against the pumpkin and raise the handle so that the tool is at an angle. Pull the tool down across the pumpkin like you’re peeling a potato; do not dig in too hard. The deep orange skin will come off like wood shavings. Scrape only the area you intend to use for your design. (There is no need to scrape the entire pumpkin, unless you want to.)
2. Next, take the small triangle mini-ribbon tool and draw your dog in the area you have scraped clean. Use most of the scraped space. To draw, hold the tool perpendicular to the pumpkin and touch it gently on the surface. Tilt it like a pencil and drag it gently across the light meat (be careful not to press too hard, as this tool is breakable). When done correctly, a small ribbon of pumpkin will come off. Do the best you can—remember, it’s only a pumpkin.
3. Using the squared-off end of the depth tool, trace the outline of your dog (the line between the dog and the background). Again, place this tool perpendicular to the pumpkin surface, and keeping it against your drawn line, dig in a little (about 1/8 of an inch) to widen and further emphasize the outline. Do this all around, which will make the dog pop out a bit from the background. Then repeat this step one more time, until the depth is just over 1/4 inch. (If the wall of your pumpkin is thinner than 1 1/2 inches, just take off the first eighth; you can always dig deeper later.)
4. Take the large loop tool and place the tip in the groove you have just created. Lean the tool so that it bites into the outside edge of the groove and gently carve away that outside line, making this groove a bit wider. Now, your dog is really sitting forward.
At this point, it’s time to think about which part of your design you wish to be darker (leave the pumpkin wall thicker) and which part you would like to glow brighter (thin out the pumpkin wall). For example, if you want your dog’s eyes to glow, you would carve very close to the pumpkin’s cavity, even punching completely through).